Forum - DrayTek 2920 AICCU :: SixXS - IPv6 Deployment & Tunnel Broker

DrayTek 2920 AICCU

Shadow Hawkins on Tuesday, 26 February 2013 04:39:59

Hello everyone, I have some problems with installing AICCU connection. Tunnel seems to be up, but not pinging and didn't work. I'm using ruled01 PoP. AICCU Configuration:

Username: DYA2-SIXXS Password: My password Tunnel Broker: tic.sixxs.net Subnet Prefix: 2a01:578:5002:a4::/64

As I have already sad, tunnel is up:

WAN22A02:578:5002:A4::2/64GlobalAICCU FE80::478:5002:A4:2/64Link

Also, I see routing table:

DestinationInterfaceFlagsMetricNext Hop 2A01:578:5002:A4::/64LANU256 2A02:578:5002:A4::/64WAN2U256 FE80::/64LANU256 FE80::/64WAN2U256 FF00::/8LANU256 FF00::/8WAN2U256 ::/0WAN2UGAF10242A02:578:5002:A4::1

But I can't ping other side of tunnel:

Pinging 2A02:578:5002:A4::1 with 64 bytes of Data: Request timed out !!! Request timed out !!! Request timed out !!! Request timed out !!! Request timed out !!! Packets: Sent = 5, Received = 0, Lost = 5 (100% loss)

What's wrong in my config?

DrayTek 2920 AICCU

Shadow Hawkins on Tuesday, 26 February 2013 04:45:51

Here is screenshots: Interface configuration Tunnel is up Routing table Ping diagnosis

DrayTek 2920 AICCU

Jeroen Massar SixXS Staff

on Tuesday, 26 February 2013 11:52:04

Contact Draytek at support@draytek.com referencing ticket [Ticket#2012100510000145] Likely you also have a broken firmware, they are apparently giving out free configuration service and beta firmwares if you contact them through the above.

DrayTek 2920 AICCU

Jeroen Massar SixXS Staff

on Tuesday, 26 February 2013 11:53:29

Subnet Prefix: 2a01:578:5002:a4::/64

That is not your subnet prefix, that is the prefix used for the tunnel. Please configure this properly, it will make things work much better already. In your case that will be 2a01:578:5002:80a4::/64 for the subnet. Still, do also contact Draytek for a newer firmware.

Please note Posting is only allowed when you are logged in.